- play_arrow Configuration
- play_arrow Configuring CTP Redundancy Features
- Enabling Ethernet Interface Failover (CTPView)
- Configuring Route Management Redundancy
- Configuring Bundle Failover Between CTP Devices at Alternate Sites (CTPView)
- Configuring Bundle Failover Between CTP Devices at the Same Site
- Configuring Bundle Failover Between CTP Devices at Both the Local and Remote Sites (CTP Menu)
- Configuring Bundle Failover Between CTP Devices at Both the Local and Remote Sites (CTPView)
- Configuring Packet Redundancy for Circuits (CTP Menu)
- Configuring Packet Redundancy for Circuits (CTPView)
- Configuring LOS Detection on CTP and SAToP Bundles (CTP Menu)
-
- play_arrow Administration
- play_arrow Checking AutoSwitch Connections for Bundles
-
- play_arrow Troubleshooting
- play_arrow Knowledge Base
-
Ethernet Interface Failover Overview
When the CTP device sends traffic over the IP network, it aggregates the traffic over its Ethernet interfaces. When you configure your Ethernet interfaces, you specify which Ethernet interface is the default Ethernet interface. In the AutoSwitch configuration, you can enable failover on the default Ethernet interface. If the default Ethernet interface goes down, the CTP device switches to the next unconfigured Ethernet interface.