close
keyboard_arrow_left
Table of Contents
- play_arrow Hierarchical Class of Service
- play_arrow Configuring Hierarchical Class of Service on MX Series 5G Universal Routing Platforms
- Hierarchical Class of Service Overview
- Hierarchical Class of Service Network Scenarios
- Understanding Hierarchical Scheduling
- Priority Propagation in Hierarchical Scheduling
- Hierarchical CoS for Metro Ethernet Environments
- Hierarchical Schedulers and Traffic Control Profiles
- Example: Building a Four-Level Hierarchy of Schedulers
- Scheduling and Shaping in Hierarchical CoS Queues for Traffic Routed to GRE Tunnels
- Example: Performing Output Scheduling and Shaping in Hierarchical CoS Queues for Traffic Routed to GRE Tunnels
- Configuring Ingress Hierarchical CoS
- Hierarchical Class of Service for Network Slicing
- play_arrow Configuring Hierarchical Class of Service on MICs, MPCs, MLCs, and Aggregated Ethernet Interfaces
- Understanding Hierarchical Scheduling for MIC and MPC Interfaces
- Configuring Ingress Hierarchical CoS on MIC and MPC Interfaces
- Per-Unit Scheduling and Hierarchical Scheduling for MPC Interfaces
- Dedicated Queue Scaling for CoS Configurations on MIC and MPC Interfaces Overview
- Jitter Reduction in Hierarchical CoS Queues
- Example: Reducing Jitter in Hierarchical CoS Queues
- Hierarchical Schedulers on Aggregated Ethernet Interfaces Overview
- Configuring Hierarchical Schedulers on Aggregated Ethernet Interfaces
- Example: Configuring Scheduling Modes on Aggregated Interfaces
- Increasing Available Bandwidth on Rich-Queuing MPCs by Bypassing the Queuing Chip
-
- play_arrow Configuration Statements and Operational Commands
list Table of Contents
Verifying the Configuration of Shaping-Rate Adjustments for Subscriber Local Loops
date_range
13-Jan-21
Purpose
Display the configured shaping rate and the adjusted shaping rate for each logical interface set configured for hierarchical CoS.
Note:
After shaping-rate adjustments are enabled and the router
has performed shaping-rate adjustments on a scheduler node, you can
configure a new shaping rate by including the shaping-rate statement in a traffic-control profile and then applying that profile
to that scheduler node. However, this new shaping-rate value does
not immediately result in shaping traffic at the new rate. The scheduler
node continues to be shaped at rate set by ANCP. Only when the ANCP
shaping-rate adjustment feature is disabled is the scheduler node
shaped at the newly configured shaping-rate.
