Uninstalling the PTX10003

Before removing a PTX10003 from a rack:

Here’s the parts and tools you’ll need to relocate the PTX10003:

Either a mechanical lift or two persons to support the weight of the PTX10003. An additional person is needed to remove the screws securing the router to the rack.
Screwdriver appropriate for your rack-mounting screws.

If you need to relocate an installed PTX10003, perform the following procedure.

Note:

When you remove multiple devices from a rack, remove the device at the top of the rack first and proceed to remove the rest of the devices from top to bottom to avoid toppling the rack.

Ensure that the rack is stable and secured to the building.
Ensure that there is enough space to place the removed PTX10003 in its new location and along the path to the new location.
Read General Safety Guidelines and Warnings and PTX10003 Installation Safety Guidelines.
Power off the device (see Powering Off the PTX10003).
Disconnect the power cords.
Ensure that you have disconnected any cables or wires attached to the PTX10003 (see Disconnecting a Fiber-Optic Cable from a PTX10003-80C).

To remove a PTX10003 from a rack:

Perform one of the following steps:
- Position a mechanical lift under the PTX10003. Use the screwdriver to remove the front-mounting screws that attach the router to the rack.
- Have two persons support the weight of the PTX10003 while another person uses the screwdriver to remove the front-mounting screws that attach the router to the rack.
Remove the PTX10003 from the rack.
Use the screwdriver to remove the mounting screws that attach the rear-mounting blades to the rear of the rack.
Place the removed screws and rear-mounting blades in a labeled bag. You will need them when you reinstall the chassis.
Transport the PTX10003 to the new location.

Uninstalling the PTX10003

Related Documentation