Symantec SGS

The JSA DSM for Symantec Gateway Security (SGS) Appliance collects events from a Symantec Gateway Security (SGS) device|appliance|service.

JSA records all relevant events from SGS. Before you configure JSA to integrate with an SGS, you must configure syslog within your SGS appliance. For more information on Symantec SGS, see your vendor documentation.

After you configure syslog to forward events to JSA, the configuration is complete. Events forward from Symantec SGS to JSA using syslog are automatically discovered.

Syslog Log Source Parameters for Symantec SGS

If JSA does not automatically detect the log source, add a Symantec SGS log source on the JSA Console by using the Syslog protocol.

When using the Syslog protocol, there are specific parameters that you must use.

The following table describes the parameters that require specific values to collect Syslog events from Symantec SGS:

Table 1: Syslog Log Source Parameters for the Symantec SGS DSM
Parameter	Value
Log Source Name	Type a name for your log source.
Log Source Description	Type a description for the log source.
Log Source Type	Symantec Gateway Security (SGS) Appliance
Protocol Configuration	Syslog
Log Source Identifier	Type the IP address or host name for the log source.