- play_arrow Overview
- play_arrow Site Planning, Preparation, and Specifications
- play_arrow Initial Installation and Configuration
- QFX10008 Installation Overview
- Unpacking the QFX10008
- Installing the Mounting Hardware for a QFX10000
- Installing the QFX10008 into a Rack
- Installing the Front Panel on a QFX10000
- Connecting the QFX10008 or QFX10016 to Power
- Connecting the QFX10000 to External Devices
- Register Products—Mandatory to Validate SLAs
- Performing an Initial Configuration of a QFX10000
- play_arrow Maintaining Components
- Handling and Storing QFX10000 Line Cards, RCBs, and SIBs
- Maintaining QFX10000 Routing and Control Boards
- Maintaining QFX10008 Cooling System
- Maintaining QFX10000 Power System
- Maintaining QFX10000 Switch Interface Boards
- Maintaining QFX10000 Line Cards
- Maintaining QFX10000 Solid State Drives
- Maintaining Transceivers and Fiber-Optic Cables on QFX10000
- Removing the QFX10008
- play_arrow Troubleshooting
- play_arrow Contacting Customer Support and Returning the Chassis or Components
ON THIS PAGE
Fire Safety Requirements
In the event of a fire emergency, the safety of people is the primary concern. You should establish procedures for protecting people in the event of a fire emergency, provide safety training, and properly provision fire-control equipment and fire extinguishers.
In addition, you should establish procedures to protect your equipment in the event of a fire emergency. Juniper Networks products should be installed in an environment suitable for electronic equipment. We recommend that fire suppression equipment be available in the event of a fire in the vicinity of the equipment and that all local fire, safety, and electrical codes and ordinances be observed when you install and operate your equipment.
Fire Suppression
In the event of an electrical hazard or an electrical fire, you should first turn power off to the equipment at the source. Then use a Type C fire extinguisher, which uses noncorrosive fire retardants, to extinguish the fire.
Fire Suppression Equipment
Type C fire extinguishers, which use noncorrosive fire retardants such as carbon dioxide and Halotron™, are most effective for suppressing electrical fires. Type C fire extinguishers displace oxygen from the point of combustion to eliminate the fire. For extinguishing fire on or around equipment that draws air from the environment for cooling, you should use this type of inert oxygen displacement extinguisher instead of an extinguisher that leaves residues on equipment.
Do not use multipurpose Type ABC chemical fire extinguishers (dry chemical fire extinguishers). The primary ingredient in these fire extinguishers is monoammonium phosphate, which is very sticky and difficult to clean. In addition, in the presence of minute amounts of moisture, monoammonium phosphate can become highly corrosive and corrodes most metals.
Any equipment in a room in which a chemical fire extinguisher has been discharged is subject to premature failure and unreliable operation. The equipment is considered to be irreparably damaged.
To keep warranties effective, do not use a dry chemical fire extinguisher to control a fire at or near a Juniper Networks device. If a dry chemical fire extinguisher is used, the unit is no longer eligible for coverage under a service agreement.
We recommend that you dispose of any irreparably damaged equipment in an environmentally responsible manner.
