Modifying a Point-to-Multipoint Ethernet Service
For a point-to-multipoint service, you can add a spoke or a hub, change the role of a device from hub to spoke or spoke to hub, change the bandwidth or MTU of a specific UNI, or add or delete a UNI.
You cannot change the interface of an existing UNI or the service VLAN ID.
To perform the equivalent of changing the interface on an existing UNI, add a new UNI with the desired interface, and then delete the old UNI.
After modifying a service, the configuration audit and functional audit information is cleared and the functional audit status is set to pending.
Modifying a service creates a new service order based on the attribute settings of the existing service.
The following topics provide instructions for modifying a multipoint Ethernet (E-LAN) service:
When you modify a service or a service order, the read-only fields in the different pages of the wizard for service or service order modification are grayed out to indicate that you cannot modify those attributes.
Adding a Spoke
To add an endpoint configured as a spoke to a multipoint Ethernet service:
Adding a Hub
To add an endpoint to a multipoint Ethernet service:
Changing a Spoke to a Hub
To change a spoke to a hub in a point-to-multipoint Ethernet service:
Changing a Hub to a Spoke
You cannot change the only hub of a point-to-multipoint service to a spoke. You will receive an error message when you try to save such a service configuration.
To change a hub to a spoke in a point-to-multipoint Ethernet service:
Adding a UNI Interface
To add a UNI on a device that is already part of a multipoint Ethernet service:
Deleting a UNI Interface or Deleting an Endpoint
You cannot delete the last endpoint on the only hub device in the service. You will receive an error message when you try to save such a service configuration.
To delete a UNI from a multipoint Ethernet service:
Changing the Endpoint Bandwidth
To change the rate limit or bandwidth for an endpoint of a multipoint Ethernet service:
Changing Advanced Settings for an Endpoint
To change advanced settings for an endpoint of a point-to-multipoint Ethernet service: